Package Contents: 5 x Cartridge Heater Voltage: 12V Nominal Power: 40 Watt Barrel Diameter: 0.236inch / 6mm Barrel Length: 0.79inch / 20mm wiring: 39inch / 1M Important Safety Guide ★Recommend Safe Working Temperature : ＜300°C ★Must pay attention to the Safe working temperature of the 3D printer's consumable and accessories, May cause high temperature hazards!! PLA (190°C-230°C)ABS (230°C-250°C) Heater Block Cotton(＜300°C) WARNING!! ►Keep away from children.►Please read your 3D printer manual carefully before installing and using it.►3D printer replacement parts, Always shut off power to the circuit before starting installation work.►This product is Designed for 3D printers, don't use it outdoor and shut off power before starting installation work.►3D printer accessories temperature can be very high, pay attention to safety!►Due to the variety of possible end-uses, it is ultimately the responsibility of the customer to determine a product's suitability for a particular application.
M**Y
could fit better
They work GREAT. Needs small modification on wanhao and maker select. They are a bit smaller diameter than the hole in the heater block. Aluminum tune shim is needed, but functionally they work great.
A**T
worked as intended
I used these heater cartridges for my e3d v6 and a homemade filament extruder. So far everything has been working fine.
F**Y
Perfect fit.
These were a perfect fit for a MK10 heater block. They fit better than the original that came with the 3d printer. Silicon wire insulation is top quality and the wire is stranded so it will stand up to the movement a flexing of the print head.
B**N
Fit and work great
These were a great fit. So far I have taken it up to 270*C and they work no problem. I highly recommend them especially for the price.
B**U
Product as described
Product as described
B**S
Solid quality cable and 3.8 ohm :)
These have nice silicon jackets and red braided guards, I was slightly worried about quality and checked the heater on my multimeter before soldering it in place. 3.8 ohm. Ideal
B**N
Five Stars
Exactly what I needed, worked immediately, and was insanely cheap.
C**F
Very poor quality control
I was expecting the resistance of these to be 3.6 ohms but they were not. They were 4.7, 4.8 10, 10,5 and 39.6 ohms. Very poor quality control.
Trustpilot
2 weeks ago
3 weeks ago
