TPO - PlayStation 2 Hard Drive Spacer - 3.5" to 2.5" - PS2 Fat (SCPH 30000 & 50000)

No trimming, cutting, or sanding needed. Fit like a glove.

This works perfectly to hold a 2.5 inch hdd or ssd in a fat Playstation 2 drive bay. Af first I was a little concerned because the plastic seemed very thin and too flexible. However it holds the dive very securely and prevents it from coming loose in the drive bay.

As others have mentioned, it was a struggle to get the pegs to fit; the best I could do resulted in it being bowed out a bit. As flexible as it is, it's fairly simple to flex it onto the points it attaches to on the network adapter, so it gets the job done. If anything, I'm not sure if the spacer would actually stay secure on the network adapter without the drive forcing the spacer to flex outwards.

A little fragile but it does the job

Great way to keep a 2.5 drive secured. It is a little rough, being 3D printed, but it works well.

I night this actually a while ago. But I finally got around to the several projects waiving for me to work on them. This bracket is too small for the SSD it was made for. There’s heat not enough clearance. Even when I barely get the nubs into the screw holes, it bows out line you see in the pics.Once inside my PS2, it eventually pries the SSD off (unseats) the male SATA port. I know it’s been too long to get a refund or perhaps have this one swapped out, but I’m not reordering another one. And if you order one, check it IMMEDIATELY to see if it fits your SSD or HDD. Thanks!

You just set the drive in the tray and you place it in the ps2 like a normal drive. Really simple setup.

Fits perfectly if your tryna mod your ps2 with a sata SSD