TOPENSTC173 Wireless Push Button for Automatic Swing Sliding Gate Opener Garage Door Opener Surface Mounted Portable Switch Security Gate Operator Accessory

We use these in our cars, having them on our visors. They work well and the remote itself can be removed and taken with you to operate from another vehicle. Which I sometimes do if I ride with someone else. Pretty handy design.

Excellent remote controller for Topens gate system... we have several around the house as they are convenient and practical! Highly recommend this and any other Topens products, they are easy to install, convenient to use and customer support is amazing!

Ordered these to use with the gate opener. Unable to assess durability as only in use for two weeks. Range is good, works consistently so far. Easily set up.

This remote works well from a good distance

This was a great addition to our Topens gate opener. We use this device just inside our house exit door to operate gate when needed. We used the screws to mount to wall where we keep the remote. Works great. Looks really good.

Very easy to use and to install great remote

This item, I keep in the garage and I always press it before getting into my car. It has never missed a beat and opens my Topen Gate flawlessly, time & time again. That's what I expect...great service & unquestioned reliability. Tested by almost 4 years of service.

The system is good and works as specified, however I have 3 issues for the manufacturer.1. The 12 volt batteries don't last. Some last a few weeks and some last a few days. Did not get the dates on them but seem to be totally erratic as to how long they will last. Even the spares that come with the units may or may not last for long.2. Locking clips on the base that hold the button on unit are totally useless. Even with great care, sliding in the button piece, after aligning clips will after 1 or 2 tries break the clips off the base unit. Then nothing will hold it in. We used a small screw with washer to make sure the button unit stays put.3. As I mentioned in my E-mail, the control board is not the same as shown in the manual. Circuits are A. not in the same place as shown, B. the unit has 5 potentiometers but the manual shows 3, C. the microswitch in the manual shows 3 toggles and our board has 5.Anyway, after all of the problems and issues, the system is now working flawlessly except for the battery issue.One question remains, must the remotes be re-programmed every time the batteries are changed? Did not notice this in the manual.