Rubber Jack Stand Pads Adapter for Hi Lift Car Jack Stands Slotted Frame Rail Pinch Welds Protector,4Pack

Well build

I don't know how I didn't have these before. They work great with the jack stands I have and fit right flush with the pinch welds. A definite if you don't want to bend or damage the car frame. They are pretty durable too. These people that said they broke these must have been lifting Mercedes G-Wagons or heavier SUV/Trucks. Either that or really abusing them or using them incorrectly. Great product for the price!

These were a little wide for harbor freight/ Pittsburgh 3 Ton model 61196. They still did a good job of protecting the pinch weld area and the material seems durable but between the gap on the jack stands and the softness of the material they deform pretty significantly during use.

Every time I jack up my car and then level it onto bare jack stands, I risk damaging the under body pinch welds. I've tried various methods like using a shaved hockey puck and other jack stand pads and most of them failed within a couple of uses (material of pad of ripping due to the sharpness of the pinch welds). This pad adapter has held up well over the past couple of months. They're wide enough to fit on top of two sets different jack stand brands: Harbor Freight and Craftsman. The pad is able to withstand the pressure and sharpness of my car's pinch welds. Wish I knew about this jack pads before spending several hours shaving down a rubber hockey puck with a dremel!

These are a really good idea and should go hand in hand with the purchase any jack stands if your car is to be lifted by the pinch welds of the frame rail. Unfortunately the rails on my car have been damaged to some extent by improper lifting. I will be using these rubber pads any time my car is on jack stands to prevent any further damage. These fit perfectly on my 3 ton stands (photo on left and middle). They are somewhat loose on my 2 ton stands (photo on the right) but still work fine as long as you watch what you're doing. I wish I had known about these sooner. Money well spent.

These may or may not fit your jack stands.In my case they fit two and they kinda fit the other two.That being said, the rubber is durable and the groove is the right range for my three cars.

Was looking for something that would eliminate some risk from when I need to use jack stands with my vehicles, which all have the frame rails which are subject to bending/damage if incorrectly lifted.These pads fit my 3-ton Craftsman jack stands perfectly. When the weight of the car is on these pads, the "V" shape cradles the frame rail perfectly. No damage, no slipping and the rubber compound held the weight of the car with no issue.Exactly what I was after for a great price.

I have a FRS that had tall pinch welds at the jack points that made me uncomfortable with how they rested on my jacks stands. these are sturdy pads that solve that problem. I have 6 ton and 3 ton jack stands and they have fairly different profiles to the top of the stand, but these blocks bit well in either profile and seem to be doing well. they appear well built, will report back after I have used them a bunch, but a first quick trial and they did what I was hoping ot make the 'footing' of the mount straddle that pinch weld nicely and seemed sturdy/stable.